Throttle Cable – 015783

Throttle Cable – 015783

• Top 1 outer length: 690mm
• Bottom 1 outer length: 485mm
• Bottom 2 outer length: 250mm
• Bottom 3 outer length: 250mm
• Outer top 1 fitting: 90′ bend, 9mm push in, special locking plate
• Outer bottom 1 fitting: 45′ bend, 7mm push in, 15mm outer diameter stop plate
• Outer bottom 2 fitting: 6mm screw over
• Outer bottom 3 fitting: 6mm screw over
• Top 1 inner overhang: 68mm
• Bottom 1 inner overhang: 70mm
• Bottom 2 inner overhang: 80mm

🖱️ Frequently clicked

• Bottom 3 inner overhang: 77mm
• Additional outer info: bottom 1 adjuster and top adjuster, bottom 1 outer has spring

🔔 Don’t miss

• Additional fittings Info: bottom 1 bend is loose
• Inner top 1 nipple: 6mm x 4mm barrel
• Inner bottom 1 nipple: 3.5mm x 5mm barrel

🖱️ Frequently clicked

• Inner bottom 2 nipple: standard carb
• Inner bottom 3 nipple: standard carb

Some bikes have one single pull throttle cable while others have two which are:

1. Throttle Cable A or 1 = (Pull)
2. Throttle Cable B or 2 = (Push)

These two cables each have a different use. The push cable however, doesn’t actually push anything, it acts as a safeguard pulling the throttle closed if the spring fails. They are both used in tension, one pulls the throttle open, the other pulls them shut when you roll the throttle forward.

The pull cable pulls the throttle open, hence the name.