The pull cable pulls the throttle open, hence the name. They are both used in tension, one pulls the throttle open, the other pulls them shut when you roll the throttle forward.
The push cable however, doesn’t actually push anything, it acts as a safeguard pulling the throttle closed if the spring fails.
Throttle Cable – 015681
- Top 1 outer length: 895mm
- Top 2 outer length: 895mm
- Outer top 1 fitting: 90′ bend, with separator points
- Outer top 2 fitting: 90′ bend, with separator points
- Outer bottom 1 fitting: 45′ bend, 6mm push in
- Outer bottom 2 fitting: 45′ bend, 6mm push in
- Top 1 inner overhang: 111mm
- Top 2 inner overhang: 111mm
- Additional outer info: both have middle adjusters, cable 2 separator clip at bottom
- Inner top 1 nipple: 6mm x 7mm barrel
- Inner top 2 nipple: 6mm x 7mm barrel
- Inner bottom 1 nipple: 5mm x 7mm barrel
- Inner bottom 2 nipple: 5mm x 7mm barrel
🔥 Trending now
Some bikes have one single pull throttle cable while others have two which are:
🚀 Top-rated
- Throttle Cable A or 1 = (Pull)
- Throttle Cable B or 2 = (Push)
These two cables each have a different use. Customer satisfaction is our top priority.
