The pull cable pulls the throttle open, hence the name. They are both used in tension, one pulls the throttle open, the other pulls them shut when you roll the throttle forward.
The push cable however, doesn’t actually push anything, it acts as a safeguard pulling the throttle closed if the spring fails.
Throttle Cable – 015645
- Top 1 outer length: 620mm
- Bottom 1 outer length: 455mm
- Bottom 2 outer length: 250mm
- Outer top 1 fitting: 10mm adjuster
- Outer bottom 1 fitting: 6mm adjuster
- Outer bottom 2 fitting: standard ferrule
- Top 1 inner overhang: 124mm
- Bottom 1 inner overhang: 79mm
- Bottom 2 inner overhang: 82mm
- Additional outer info: bottom 2 outer has spring
- Additional fittings Info: top adjuster is loose
- Inner top 1 nipple: 6mm x 5mm barrel
- Inner bottom 1 nipple: 6mm x 5mm barrel
- Inner bottom 2 nipple: standard carb
Some bikes have one single pull throttle cable while others have two which are:
- Throttle Cable A or 1 = (Pull)
- Throttle Cable B or 2 = (Push)
These two cables each have a different use. Limited stock available – don’t miss out!
